Scope Weaver Base Picatinny Rail Mount for Dan Wesson Vent Rib Barrel Revolver

A revolver scope base rail in anodized black finish for Dan Wesson revolver with vent rib barrel. The rail has 13 ring slots which make it easier to set up eye relief and find more desired placement of scopes or red dot sights on top of the revolver. No drilling is needed. The scope rail is clamped onto the vent rib using the hex screws and two side plates. There are also two supporting hex screws on both top ends of the rail each with a locking screw. The supporting hex screw can be used to rest against the top of vent rib to give additional support. Just let the tip of the supporting hex screw to touch the top surface of vent rib and do NOT overtighten the screw which can mar the finish on the vent rib. Unlock the locking screws first to apply these supporting hex screws and remember to tighten up the locking screws afterward.

Top rail is compatible with weaver or picatinny style rings and also will mount red dot sight or those RMR micro red dot sight. Machined from extruded aluminum alloy. Mounting screws and L hex wrenches are included with the unit.

Rail type: weaver and picatinny

Number of ring slots: 13

Overall length: 5 1/4”

Finish: Anodized matte black

Weight: 3.4oz

* Always a good idea to factor in the recoil expected and consider the weight of the scope or red dot sight and choose what to use with the rail. When mounting the rail onto the revolver, Check alignment of the rail with the center line of barrel before tightening the clamping screws. Using blue Loctite thread locker glue is recommended and check on the screws periodically as they might become loose due to recoil.

Always be sure to unload and practice safe gun handling when mounting the rail.